Mobile Cell Phone Battery Charging Problem and Solution – How to Solve Not Charging Problem in any Mobile Cell Phone

This chapter explains Mobile Phone Charging Problem and Solution –How to Solve Charging Problem in any Mobile Cell Phone. These problem and solution apply to all brands and make of mobile phones including Nokia, Samsung, iPhone, China Mobile Phones, Motorola, HTC, Sony, Blackberry, Alcatel, Apple, AudioVox, Benefone, Danger, FIC, Hagenuk, Palm, Kyocera, LG, Panasonic, Huawei, ZTE, Spice, Lava, Sony Ericsson, Micromax etc.


What is Network Section in a Mobile Cell Phone?

  Charging Section in a mobile phone is the section that helps to charge the battery. This section is controlled by the Charging   IC or Power IC.


Types of Faults or Problems with Network in any Mobile Cell Phone

   Battery of the mobile phone is not charging at all.

   There is sign of battery charging but the battery is actually not getting charged.

   When the charger is inserted, it shows Not Charging.

   When the charger is connected it shows Bad Connecting Charging.
 
   When the charger is inserted the mobile phone gets hot.
 
 Mobile Cell Phone Charging Problem and Solution – How to Solve Charging Problem in any Mobile Cell Phone

1.Change the charger and check. Voltage must be 5 to 7 Volts.
2.Clean, Resold or Change the Charger Connector.
3.If the problem is not solved then change the Battery and Check.
4.Check Voltage of the Battery Connector using a Multimeter. Voltage must be 1.5 to 3.7 DC Volts.
5.If there is no voltage in the connector then check track of the charging section. Refer to the diagram of the particular model   of the mobile phone. Books with track diagrams are easily available in the market. The same can also be searched on the   internet.
6.If the problem still persists then check Fuse, Coil and Regulator one by one. Change if required.
7.If the problem is still not solved then Heat or Change the Charging IC.
8.Finally Heat, Reball or Change the Power IC.

Note:

   .If the mobile phone shows “NOT CHARGING” then change the Battery and check. If the problem is not solved then remove the    charging regulator (no need to change it). If the problem is still not solved then change the R22. If the problem is still not    solved then remove the two capacitors above the Battery Connector (No need to change). If the problem still persists then    change the Charging IC.
 
  . If the Hand Set Shows “FALSE CHARGING” then use a 3.6 Volt Zener Diode and do Direct Charging.